ControlBASS
Which Firmware Version is my MK3 Speaker Running?
To see which version of firmware your BASSBOSS MK3 speaker is running, connect the loudspeaker to a computer running ControlBASS via a Cat5 (ethernet) cable, power on the loudspeaker, and look at the version string when it pops up (see the image ...
Does the speaker show limiting in the ControlBASS app?
Q: Is there a way to know when the speaker is going into the limiter from the ControlBASS app? It would be great to know if the volume is hitting the limit instead of having to check behind the speakers for the green light. A: The LED on the back of ...
MK3 Cabinets Not Recognized in ControlBASS
If your MK3 Cabinets are not recognized in ControlBASS: Check whether the LAN Link LED is lit. If the LAN link LED is not lit, possible causes for a lack of connection are: The physical connection is bad due to a dirty or damaged connector, Check the ...
ControlBASS and MK3 integration with pre-MK3 cabinets
Q: I have a question regarding the ControlBASS software and potential integrations with older models. I have the SSP118 MK II's. If I were to purchase an MK3 version, could I use the XLR output from that to feed the MK II the same signal? Or would ...
How to Read the MK3 Preset Names
Due to the fact that the software doesn’t allow room for a full description of all the filter parameters, the information displayed is confined to the elements that are different rather than including all the parameters. All the high-pass filters are ...
MK3 ControlBASS programming update process
To update programming in MK3 models via ControlBASS follow these steps: Loading Factory Settings and Updates with ControlBASS software (Preliminary software release) The procedure is as follows: 1. Install the software. (Mac and Windows versions are ...
How many curves or presets can be loaded onto BASSBOSS MK3 speakers?
All BASSBOSS MK3 loudspeakers include Integrated comprehensive DSP. 96kHz sampling rate with 8 pushbutton presets. All presets include high pass filters, low pass filters, phase alignment, equalization and multi-stage limiting. Storage capacity for ...
Recent Articles
Sublim8 FAQ
Does the Sublim8 come with covers and a cart? Yes, the Sublim8 includes 3x transport covers (one for the sub, one for the spacer, and one for the top section) and a wheel cart for transporting. The cover features velcro to keep the top and spacer ...
SSP118 vs DJ18S - Which Is Right For Me?
BASSBOSS makes two single 18" subwoofers, the DJ18S and the SSP118 (plus the new Sublim8 system, which features an 18" Subwoofer). Naturally many people want to know the difference between these products. Many will look at the spec sheet and notice ...
Sublim8 vs Other BASSBOSS Products
The BASSBOSS product lineup is expanding with the brand new Sublim8. This document explains the difference between the Sublim8 and other BASSBOSS setups. The Sublim8 is an entire system featuring an 18" low frequency transducer, 2x 8" mid frequency ...
Wiring and Setup Guide for BASSBOSS MK3 Subs + Tops
This article explains how to wire up combinations of several BASSBOSS subs + tops for maximum performance! 2 Subs, 2 Tops: A 2 sub, 2 top combo makes for a great stereo system. The subs can either be placed together in the middle of the room for ...
Removing and Reinstalling a MK3 Amplifier Assembly
As part of a service ticket, we may ask you to remove or replace the amplifier assembly of your BASSBOSS MK3 loudspeaker. The amplifier assembly is the part of the loudspeaker that contains the metal heatsink on the back of the speaker, usually ...