ControlBASS and MK3 integration with pre-MK3 cabinets

ControlBASS and MK3 integration with pre-MK3 cabinets

Q: I have a question regarding the ControlBASS software and potential integrations with older models. I have the SSP118 MK II's. If I were to purchase an MK3 version, could I use the XLR output from that to feed the MK II the same signal? Or would that not work? 

A: The outputs from the cabinets, all the cabinets, is a direct pass-through, so they can be connected in any sequence. All the presets in all the MK2 and MK3 models are compatible with each other.
    • Related Articles

    • MK3 Cabinets Not Recognized in ControlBASS

      If your MK3 Cabinets are not recognized in ControlBASS: Check whether the LAN Link LED is lit. If the LAN link LED is not lit, possible causes for a lack of connection are: The physical connection is bad due to a dirty or damaged connector, Check the ...
    • Video | Rewiring Pre-MK3 Subwoofer

      David Lee demonstrates how to rewire a sub amp after replacement or repair. <br> See Also Video: Rewiring Pre-MK3 Top Amps Video: Removing Pre-MK3 Subwoofer Amps Video: Reinstalling Pre-MK3 Subwoofer Amps All Service Videos
    • Video | Removing and Installing Pre-MK3 DSP

      David Lee shares how to remove and Install Pre-MK3 DSP. <br> See Also: Video: Removing a BASSBOSS Pre-MK3 Top Amplifier Assembly All Service Videos
    • Video | BASSBOSS Pre-MK3 sub amp removal

      David Lee shares how to remove BASSBOSS Pre-MK3 Sub Amp. Step by step instructions are below. Subs Amp Removal: There are 12 Allen head screws around the perimeter of the heat sink: Remove the screws with a 3mm Allen wrench. Make sure the Allen ...
    • Video | Rewiring BASSBOSS Pre-MK3 Tops

      David Lee shares how to rewire a pre-MK3 BASSBOSS top amplifier <br> See Also: Video: Rewiring BASSBOSS Pre-MK3 Sub Amps Video: Removing BASSBOSS Pre-MK3 Top Amps All Service Videos