BASSBOSS always uses drivers with the push-to-release system but the other types are made and sold (see photos below - the first image is of BASSBOSS standard connectors. The second image is the type which requires this solution). If you get service replacement drivers with the incorrect connectors, it's an easy fix.
The connection to those is best done using a 1/4” Faston connector. Those are crimped onto the end of the wire and don’t require any soldering. The connectors can be purchased at hardware stores or online.
Gardner Bender 1/4 in. Fully Insulated Wire Disconnects in Blue (15-Pack) 15-153F
A proper crimp tool, something like this, and a good, hard squeeze is also required.
Southwire 9 in. Non Insulated Crimping Cutting Tool Connectors 58993640
