MK3 and ControlBASS
MK3 Cabinets Not Recognized in ControlBASS
If your MK3 Cabinets are not recognized in ControlBASS: Check whether the LAN Link LED is lit. If the LAN link LED is not lit, possible causes for a lack of connection are: The physical connection is bad due to a dirty or damaged connector, Check the ...
ControlBASS and MK3 integration with pre-MK3 cabinets
Q: I have a question regarding the ControlBASS software and potential integrations with older models. I have the SSP118 MK II's. If I were to purchase an MK3 version, could I use the XLR output from that to feed the MK II the same signal? Or would ...
How to Read the MK3 Preset Names
Due to the fact that the software doesn’t allow room for a full description of all the filter parameters, the information displayed is confined to the elements that are different rather than including all the parameters. All the high-pass filters are ...
MK3 ControlBASS programming update process
To update programming in MK3 models via ControlBASS follow these steps: Loading Factory Settings and Updates with ControlBASS software (Preliminary software release) The procedure is as follows: 1. Install the software. (Mac and Windows versions are ...
How many curves or presets can be loaded onto BASSBOSS MK3 speakers?
All BASSBOSS MK3 loudspeakers include Integrated comprehensive DSP. 96kHz sampling rate with 8 pushbutton presets. All presets include high pass filters, low pass filters, phase alignment, equalization and multi-stage limiting. Storage capacity for ...