When replacing a driver, do I need to solder the connections?
BASSBOSS always uses drivers with the push-to-release system but the other types are made and sold (see photos below - the first image is of BASSBOSS standard connectors. The second image is the type which requires this solution). If you get a service replacement drivers with the incorrect connectors, it's an easy fix.
The connection to those is best done using a 1/4” Faston connector. Those are crimped onto the end of the wire and don’t require any soldering. The connectors can be purchased at hardware stores or online.
Gardner Bender 1/4 in. Fully Insulated Wire Disconnects in Blue (15-Pack) 15-153F
A proper crimp tool, something like this, and a good, hard squeeze is also required.
Southwire 9 in. Non Insulated Crimping Cutting Tool Connectors 58993640
Related Articles
Video | Inspecting a BASSBOSS driver
David Lee explains how to Inspect a BASSBOSS Driver.Video | Packing a BASSBOSS Driver
David Lee shares information on packing a sub amp for replacement or repair.Video | Do I need to burn in my speakers?
The process of break-in isn't necessary. The recommendation is never to go from off (cold) to full power. This applies whether the driver is brand new or 10 years old. Allow the heat to build slowly, which is to say for a few minutes, before pushing ...Video | No sound from speaker - simple driver testing
Amp seems to be fine, but no sound from the speaker? Having issues of no sound from a unit? Here’s how to do a basic test of the driver/woofer to see if it's causing the issue, or if the amplifier should be considered. For testing the woofer, you ...Replacing protection lightbulbs in pre-2020 BASSBOSS subwoofers
If you see a light glowing inside your pre-2020 BASSBOSS subwoofer cabinets, don't panic! High-powered lamps are provided as a safety mechanism to keep the drivers alive, even if the system is being pushed really hard. Heavy-duty, ...